Please note - Silmid.com will be offline for 10 minutes between 9:15AM and 10:00AM while we deploy updates, we apologise for any inconvenience this may cause.
Ardrox 2302 Seal Heavy Duty Paint & Carbon Remover 25Lt Pail
Ardrox 2302S is a Corrosion Inhibitor supplied in a 25Lt Pail
Technical Information
- UN Number NON HAZ
- Commodity Code 27101999
- Country of Origin France
Data Sheets
Download the Ardrox 2302 Seal Heavy Duty Paint & Carbon Remover 25Lt Pail technical data sheet (TDS) and the Ardrox 2302 Seal Heavy Duty Paint & Carbon Remover 25Lt Pail safety data sheet (SDS) from Silmid today. Once you have logged in or signed up, the datasheet will be visible for download if one is available. Please login to access DatasheetsProduct Information
Ardrox 2302 is a mixture of solvents, activators and corrosion inhibitors. It consists of two layers: an upper layer oil seal to prevent evaporation of the active paint removing solvents in the lower layer. Ardrox 2302 contains no phenolic compounds, aromatic solvents or heavy metals. Ardrox 2302 will remove a wide range of paint schemes including baked acrylics, epoxies, polyurethanes, and phenolics. It will also remove carbon or carbonaceous deposits, polymerized gum and lacquer deposits.
Application:
Ardrox 2302 is used as supplied. The total content of the container must be emptied into the tank. The recommended operating temperature range is 80 - 110°C (176 - 230°F). The product may be used for short periods at higher temperatures up to a maximum of 140°C (284°F) for removal of more obdurate finishes. In all cases, ensure, that the seal is properly maintained and all local regulations complied with, considering the 108°C (228°F) flash point of the lower layer.
- Immersion - Immerse dry components to be stripped in Ardrox 2302 in the lower layer until paint or carbon deposits have become fully softened or detached.
- Drain - drain components (over Ardrox 2302 tank) for approximately one minute.
- Immersion - Immerse components in an Ardrox primary cleaner at 10% by volume at room to reduce vapors and aid subsequent pressure rinsing.
- Pressure rinse - Pressure rinse components. The use of an Air/Water Gun or high pressure water rig is recommended.
- Dry - Dry components thoroughly using compressed air (or an air recirculation oven at 40- 80°C / 140 - 176°F).
Approvals:
- CFMI - CFM56
- GE Aviation - SPM 70-80-04
- IAE - V2500
- Pratt Whitney - SPM 70-12-00
- Rolls Royce - CSS 235 OMat 1/226
- SNECMA - DMR 70-129
Conformances:
- USAF - MIL-PRF-83936C
- Messier/Bugatti/Dowty - PCS 2700°F
- ASTM = ASTM F-519
Physical Chemical Properties:
- Appearance - pale straw-colored, diphase liquid
- Density (typical) g/ml 1.05 to 1.07 @ 20°C (68°F)
- Flash Point (upper layer) °C (°F) 190 (374) Cleveland Open Cup
- Flash Point (lower layer) °C (°F) 108 (228) Cleveland Open Cup
Shipping information
International delivery (door to door delivery) is available for selected countries worldwide. Shipping will be automatically calculated based on the weight, location and hazardous nature of the goods. Customers can also choose ex works to arrange their own collection.
Please refer to our delivery page for more information.